Leave Your Message

3S LIFT Rack and Pinion Tower Climber

It is an automatic climbing device installed on existing ladders in/on any vertical tower building. 
It has features of compact structural design, stable running, higher safety, easy operation, simple installation/disassembly, etc., ensuring the auto climbing is safer and more efficient to reach the tower top.
Key technologies are innovated and patented by 3S LIFT, including fall protection, multi-mode control, and rack & pinion transmission. 
It has been certified by CE certification and European standards.

    product description

    Upper-End-Stop-with-Buffernoe

    Upper-End Stop with Buffer

    Two mechanical end stops with buffers are installed at the upper and lower ends of the guide rail, respectively. This can prevent the car from overrunning the running pathway in the event of switch failure.

    Operator-Fall-Arresterh1j

    Operator Fall Arrester

    The Operator fall arrester is connected to the guide rail and full body harness. When accidents happen, fall arrester locks inside the guide rail immediately to prevent serious injury.

    Manual-Descent-Functionxja

    Manual Descent Function

    In case of sudden power failure, the operator can operate the manual descent lever to descend the car safely and steadily.

    3S LIFT Ladder Hoist Tower Climber img 02kry
    Car-Fall-Arresteri2e

    Car Fall Arrester

    The Car Fall Arrester is located on the lift’s car and runs inside the guide rail. It locks immediately in case of a fall, keeping the car in place and preventing it from falling.

    Overload-Protection-Systemqsy

    Overload Protection System

    Should an overload occur, the Tower Climber will sound an alarm, and the power will instantly be cut off, stopping the lift in place. The Climber will not start again until the overload is corrected.

    Lower-End-Stop-with-Buffer0pz

    Lower-End Stop with Buffer

    Two mechanical end stops with buffers are installed at the upper and lower ends of the guide rail, respectively. This can prevent the car from overrunning the running pathway in the event of switch failure.

    Key Features

    01

    Two-handle start-up switch

    02

    Remote operation system

    03

    Top and bottom limit and ultimate limit protection

    04

    Low battery protection function

    05

    Audible and visual alert while running

    06

    Collapsible footboards

    Specifications

    Specifications of the Tower Climber models

    Model

    T150

    Corrosion protection

    C4-L

    Capacity

    1 person

    Operating temperature

    -20°C to +55°C

    Dead weight

    70 kg

    Relative humidity

    <95%

    Rated load

    150 kg

    Ambient wind speed

    ≤13 m/s (strong breeze)

    Dimensions

    (380 × 560 ×1340) mm

    Motor power

    1 kW

    Rated speed

    18 m/min

    Insulation class

    F

    Battery range

    ≤1500 m
    (40 round trips for a 40 m tower crane)

    Service life

    10 years

    Noise level

    ≤79 dB (A)

    Power supply

    Battery powered
    Nominal voltage DC48 V

    IP rating

    IP65

    Rated voltage

    220 V 50 Hz

    Leave Your Message